In an earlier contribution to this discussion,
fred wrote:

In article , Set Square
writes
In an earlier contribution to this discussion,
Kalico wrote:

[snip]

something like this ?
http://www.screwfix.com/app/sfd/cat/...18649&ts=48872

Indeed

I looked at some of those in one of the sheds. They would do at a
push, but are really too large in diameter relative to the central
hole - pushing the hole in the worktop too far out from the corner.
I reaaly want a smaller flange than this.

How about a pipe stiffener for mdpe in white nylon as is has the
through hole sleeving and a small diameter flange to finish the top
surface. I've got one for 25mm here which is a bit too small (20o/d,
17i/d), but one for 32mm pipe would prob do the job (guess 27o/d,
24i/d?). Plumbers'
merchant will prob have one offs. Doesn't meet your chrome finish
spec,
but you could place a bright plated or stainless washer under the
flange. I've tried it here & it looks ok but is actually less
obtrusive without the washer. Or do some mfrs make their stiffeners
in Ali?

Hope you can visualise the idea.


I think that's the best idea so far - many thanks.
--
Cheers,
Set Square
______
Please reply to newsgroup. Reply address is invalid.