Semi tempted by this thought - but for 2 things - 1 getting the right
seal - I can't find any mention of this particular setup on the web
anywhere! and 2 - the top of the cylinder looks so rusted, that if all
the rust is removed and cleaned away, it'll be impossible to reseal as
the cylinder is so pitted and rusted...

My neighbours had theirs replaced (by their landlord) - So I'll call
them and see if they can take a look - whilst on DIY issues I'd say
I'm 8/10 er, I'm not at all ofay with this type of setup....



"BigWallop" wrote in message ...
"The Natural Philosopher" wrote in message
...
BigWallop wrote:


Now go out and buy a big wire brush and some scouring pads and clean the
whole up. Once youve done that, then more than likely you'l be able to
reseal the plate and tank back together no problem with some proper
neoprene
sealing rings. But it all has to be shiny clean.



Do you really think it can be resealed to 5 bar tested?
Safely?


Not disagreeing, just curious.


Depends on how competent the OP is, although the banding does a lot of the
work in pulling the two bits back together again, and as long as the correct
seals are used, then it is a job that can be done by someone who's good with
their hands and head (as in a bit of brain power). :-))


---
http://www.basecuritysystems.no-ip.com

Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.560 / Virus Database: 352 - Release Date: 08/01/04