"Thomas Prufer" wrote in message
...
On Fri, 04 Jul 2003 19:35:45 +0100, Peter Parry
wrote:
Yes - but they are clip on 1/4" or whatever and the shank is too wide
to go in the holes for most recessed screws on small domestic
appliances.
Sometimes grinding a slot in the back of the 1/4" bit with a Dremel
helps. You still need clearance for the bit, but not for the holder:
drop the bit in the screw recess and used a flat screwdriver on the
back end of the bit.
Thomas Prufer
You beat me to that suggestion Thomas, in fact all my driver bits have a
slot cut in them with a junior hacksaw for that very same reason. And a
good magnet against your screwdriver doesn't go a miss either on the really
deep recesses.
---
BigWallop
http://basecuritysystems.no-ip.com
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (
http://www.grisoft.com).
Version: 6.0.495 / Virus Database: 294 - Release Date: 30/06/03