On 2/9/2021 4:41 PM, DerbyDad03 wrote:
On Tuesday, February 9, 2021 at 2:39:32 PM UTC-5, Leon wrote:
On 2/9/2021 10:43 AM, DerbyDad03 wrote:
On Tuesday, February 9, 2021 at 9:01:36 AM UTC-5, StevenWoodward wrote:
Built this clip-on infeed support, and found it to be very handy when using sleds, , to stop the sled falling off the front of table saw.
It provides most of the benefits of an infeed table, and still allows me to move my body right up to the front of saw.

Here is a video showing how it works and how to make one: https://youtu.be/pp-9-CZes2I
https://www.homeownershub.com/img/18gz


Grab your router and add a miter gauge slot.

You do not need a miter bar slot. Place on the outside of the miter
slots or between.

It isn't a "need", it's more of a "might as well".

For the simple step of routing the slot, you get solid support for
both sides of a miter gauge. You can set it on there and walk away.

Izzy Swan likes having one, and he uses a SawStop, so he's pretty smart. ;-)

https://d2j6dbq0eux0bg.cloudfront.ne...1667131895.jpg




I will have to disagree. Little support is actually needed unless you
are cutting very wide, and in that case you don't need a sled.