On 05/12/2020 16:03, The Natural Philosopher wrote:
On 05/12/2020 11:22, The Natural Philosopher wrote:
On 05/12/2020 09:47, Jeff Layman wrote:
On 05/12/2020 08:13, The Natural Philosopher wrote:
On 05/12/2020 08:08, Jeff Layman wrote:
On 04/12/2020 21:25, The Natural Philosopher wrote:


Every time I do a wash - which seems to be working fine - there is a
little puddle of water on the floor by the filtery thing at the
bottom
right.

Machine is a curry's essential C510WM12 ...

I cant see if there is any kind of seal gone on the removable filter
thing at all and it doesn't seem to be a purchasable spare part...

any ideas?

I had a look at the manual online and it looks like just about any
other
filter.

yup. I agree

What about temporarily sticking sellotape, duck tape, insulating tape,
etc where the filter plug meets the filter body. It should be
enough to
seal it for a couple of washes. If you don't get water on the floor
that
would suggest it's the fit between the plug and body.

It tightens up very 'hard' as if there was no rubber seal.

Maybe a tiny piece
of grit preventing a perfect seal? If it still leaks, then it's
something else. Hairline crack in the plug or body? Leak higher up
which
is running down the filter body, and so it just looks like it's the
filter itself which is leaking?

Good thoughts.

What should actually be in there? I had expected some kind of gauze,
but
there is none.

I'm not sure. I think there was a fairly coarse gauze or sieve in
ours, but it wasn't removable. I'm sure bits and piece like loose
buttons might be stopped by it and you just then pulled them out the
front. I can't even remember if the filter plug on ours had a rubber
washer, and I'm loathe to remove to check in case it starts leaking
when I put it back!

On the Smeg which was left when we moved in there was a bracket which
screwed down to prevent the filter plug turning and loosening
slightly through vibration. Is it possible your plug might have
turned a fraction and so allowed a small leak?

There is something whose purpose I do not understand there, and when
trying to tighten it I seem to reach a hard stop.

I will have another look


I removed the rubber ring seal and reversed it and now it tightens up
with more sponginess.

I will report back next wash. 14 days prolly


Well! I did two washes today and no leaks. It looks like the washer had
been compressed too much

It also looks like standard basin drain washer might fit if it happens
again...


--
"The most difficult subjects can be explained to the most slow witted
man if he has not formed any idea of them already; but the simplest
thing cannot be made clear to the most intelligent man if he is firmly
persuaded that he knows already, without a shadow of doubt, what is laid
before him."

- Leo Tolstoy