On Wed, 18 Nov 2020 19:46:29 -0500, Joe Gwinn
wrote:

On Wed, 18 Nov 2020 18:27:22 -0600, Leon lcb11211@swbelldotnet
wrote:

On 11/18/2020 5:05 PM, Michael wrote:
This looks like an interesting and functional way to make a stopped dado. Has anyone tried it?

https://youtu.be/to1YsOjOhv8?t=71


I highly suspect that he is using a milling machine and not a drill
press. A milling machine is designed for a side load, the typical DP is
not. It would work for a while but the bearings would likely wear out
sooner than later.

Yes, he is using a vertical milling machine, most likely some kind of
Bridgeport. You can see the standard mill table, which he is cranking
back and forth.

.https://en.wikipedia.org/wiki/Bridgeport_(machine_tool_brand)

You are of course correct and I am not very observant. Certainly a
good way to do it if you have a real milling machine, but a bit
overkill if you're buying one for the purpose.