Posted to uk.d-i-y
|
|
SDS drill bit stuck in wall
On 12/05/20 19:37, wrote:
On Monday, 11 May 2020 19:22:08 UTC+1, ARW wrote:
On 11/05/2020 19:00, Harry Bloomfield wrote:
George Miles submitted this idea :
One of my 1.5 meter SDS drill bits is stuck in the wall.
The drill, a Titan, appears to have a clutch which means it makes a
noise but doesnt turn.
The wall is an mix of stone and lime cement.
Any tips on how to get it out please?
[george]
Angle grinder :-)
Cut it off at the wall face and leave it.
I have done that in the past (actually it was into a floor).
Sometimes running another drill bit alongside the stuck drill bit can
free it off.
Yup. Of course you might end up with a cluster of jammed bits
Always give the bit enough time to clear debris, ie retract it every so often. Pushing ahead without pause invites jams - of course there are other causes too, such as loose infill stones in thick walls. If that's the issue it's going to be hell getting through it.
In old buildings with thick, but hollow, walls with a rubble infill you
can't stop now and again to retract the drill. All that does is cause
the rubble to fall down and block the hole you've just drilled. A friend
of mine had just that problem trying to put a pipe through the 30 inch
thick walls of a 17th C house. I think that in the end, after drilling
through the wall he left the bit in place, put the pipe up against the
end of it, and used a mallet to drive the pipe and bit through and out
the other side. The rubble had no opportunity to fall down using that
method.
--
Jeff
|