I have a device (which provides low pressure air flow) that has a male
1" BSP thread on the end ..... this goes into a clearance hole and
fastened by a 1" BSP nut.
I want to move this out so that it joins via a swept bend something less
than 90 degree (70 or 80 would suffice) or 110 degree if looking at the
bend angle.
I need 1" BSP parallel male thread on one end and 1" BSp parallel female
on the other.
something like:
https://imgur.com/a/puIIz3d
My thought are I take a piece of 28mm copper pipe, bend to suitable radius.
On one end solder a 28mm x 1" BSP male endfeed
https://tinyurl.com/rf8dlwa
On the other a 28mm x 1" BSP Female endfeed
https://tinyurl.com/ssgkrng
Anybody know of a neater way ?
Needs to be copper/brass (not iron)