On Sunday, 26 January 2020 02:27:10 UTC, williamwright wrote:
Basically you have to connect to the backplate, fix that to the wall,
then fit the unit onto the backplate. The terminals are rather peculiar.
It seems that you're expected to push 8mm of bared connector into a sort
of clip thing. Fair enough, except that the diameter of the bared bit of
wire is extremely critical. It's more than likely that the wire you've
used just drops out. Suppose you do get it to stay in, but then you want
to get it out? The pictogram suggests that you put a screwdriver to the
very fragile sliver of plastic that covers the terminal. As far as I can
figure out this just breaks the plastic off. Is it me?

Bill

No, if you hear the chime it's someone else.
I'm not familiar with it - can you solder them on?


NT