Butt hinge for aluminium garage door
On Friday, 6 December 2019 18:52:17 UTC, newshound wrote:
On 06/12/2019 16:04, tabbypurr wrote:
On Thursday, 5 December 2019 19:54:35 UTC, AnthonyL wrote:
The garage opening is side hinged with one part being about a normal
size door width and the other being a lot wider.
The lower hinge of the smaller door broke today. It's made of brass.
The door does catch a bit as it's opened but not that much.
Anyway I may as well replace both top and bottom hinges but any tips?
Should I go brass again? Or steel? Rust? Security?
I'll probably pop-rivet into the aluminium door and wood screws into
the side frame unless suggestions are otherwise.
Steel + ali results in much accelerated corrosion of the ali. Not a good combination
NT
But only if it gets damp.
I'm pretty sure outdoor things do.
|