On Monday, 11 November 2019 17:47:02 UTC, ARW wrote:
On 11/11/2019 12:54, Lee Nowell wrote:
I have just checked my transformers and they say 20 - 60 W/VA so looks like these won't work. Thanks for the tip everyone will know source a GU10 lead and hopefully the bulb diameter is the same and I can reuse the fitting.


Depending on your fittings the problem of making the GU holder fit is
just down to pot look. Sometimes they are dome shaped, sometimes they
are flat.I had to try a few wholesalers last time before I got one that
fitted.

--
Adam

Thanks Adam. The fitting itself is one of these.

https://auroraclearance.com/au-dll991.html

the front screws off and inside is an MR16 fitting (like this https://www.toolstation.com/spare-lampholder/p99286) with the bulb itself clipped onto the ring I took off the front. My thinking was to replace the MR16 lamp holder with a GU10 one and wire it and the mains into the junction box at the top (may need a bigger junction box though as holes are small). Does this seem viable?

thanks

Lee.