Welding vs. Tapping vs. Roll Pin
On Tuesday, October 8, 2019 at 5:04:41 PM UTC-4, wrote:
On Tuesday, October 8, 2019 at 9:22:33 AM UTC-4, wrote:
I want to permanently attach 3/8" diameter rods to 3/8" rods end-to-end and was looking for advice on the best way to accomplish this. The methods I'm considering are welding, tapping, or use of a roll pin.
The rods will only be about 3-1/2" long, and the pieces that I want to attach are 1/2" long.
Perhaps a combination of the attachment methods mentioned for this rod extension project would be warranted.
Any advice would be appreciated.
Thanks.
Darren Harris
Staten Island, New York.
I think there must be a lot you have not mentioned. Otherwise you would just use a longer rod to begin with and not have to do any attaching.
Dan
It comes down to what I already have and have access to.
Darren Harris
Staten Island, New York.
|