View Single Post
  #2   Report Post  
Posted to rec.crafts.metalworking
Bob La Londe[_7_] Bob La Londe[_7_] is offline
external usenet poster
 
Posts: 1,768
Default Good Length and Weight for Slide Hammer

On 8/28/2019 8:40 AM, Bob La Londe wrote:
A common tool in a mold shop (I am told) is a siide hammer pin puller. I
don't have one, but I have had to pull a few pins.Â* If the end of the
pin has a flat what I have done is drill and tap it, then drill and
pilot drill a larger piece of stock to make a pulling sleeve.Â* One hole
is large enough to fit over the pin, and the next is clearance size for
a machine screw.Â* I hold the sleeve, and screw in a machine screw.Â* This
draw the pin right out of the hole.Â* Works similarly to a bearing or
wheel puller.

There are a couple problems.Â* First is its slow, and often I can't find
the last one I made and its faster to just make another one.Â* Next is
that often there is little or no flat on the pin I need to pull.Â* For
alignment pins in molds I put a radius on the end so that the molds go
together faster and easier for the end users.

I can quite often get a grip on a pin with a pair of vise grips and
twist it, but its extremely difficult to twist it out.Â* What I have
heard of, read, and been told a couple times is that lot of guys will
take a pair of Vise Grip pliers and make a slide hammer out of them, by
replacing the adjusting screw with a piece of decently tough rod like
4140 with a knob on the end. Then put a slide weight on the rod.Â* They
grip the pin with the pliers and knock it out with the slide hammer
portion.

I can certainly make the slide hammer as a replacement for the
adjustment screw, but I wonder how long the slide bar needs to be to be
effective.Â* I imagine if its to short you wont be able to get much
striking force without straining yourself, and if its to long it will be
awkward to use and to store.Â* If I were to hold a small mold in my hand
I can't imagine being comfortable with more than about 16 inches of rod.
Â*Maybe 10-12 inches of hammer travel.Â* If I clamp a larger mold to a
bench I might be able to go a bit further, but striking up could be
awkward if its to long.

Then there is weight.Â* I'm pretty comfortable with a 3lb cross pien
hammer.Â* When I need to move something with a hammer that's the one I
reach for, but this is a whole different movement.Â* Would 2 pounds be
more easy to control?Â* Would 4 lbs deliver more usable force due to
limited striking distance?



P.S. I'm frugal and I hate to waste stock making two or three of them.
(Ok cheap.) Whatever I make is likely to be what I live with
indefinitely.