On Sunday, May 12, 2019 at 6:51:53 PM UTC-4, Gramps' shop wrote:
No luck finding a local kiln so I have decided to build a dehumidifier kiln that will reside in my basement shop. In essence, it will be a 2x2x8 box of 1/2 inch osb board with a fan on one end and the dehumidifier on the other. Question about heat source: will a small ceramic heater be sufficient? I also will get a thermostat device to control the temperature. What temp should I shoot for during initial drying (want to kill any remaining critters). I want to avoid checking and will seal the ends.
As always, your good counsel is appreciated!
This might help...
http://forestryforum.com/board/index.php?topic=84835.0
Interesting points on "casehardening" if the kiln is run for too long of
a straight stretch. That topic is also covered here, with diagrams:
https://www.fs.usda.gov/treesearch/pubs/35061