On 05/04/2019 12:39, Dan S. MacAbre wrote:
I doubt it,

Aboslutely it can

Many houses are totally timber framed.

Mine is, and some of the stud walls are much closer studs and feature
double skins of plywood AND plasterboard to prevent bowing

The oputer walls are all 6x3 skinned with plywood for structural strentgh

but I want to saw a big hole in one, so I need to ask.Â* Our
stairs go up the middle of the house, at 90 degrees to all the beams.
There is a breeze block wall on one side, and a stud wall on the other,
which continues down into the kitchen.Â* I'd like to open up the space
under the stairs a bit by removing a big chunk of the stud wall.Â* In the
void, above this wall is a larger-than-the-others beam at 90 degrees to
all the others, and fastened to another very large one in the region of
the top of the stairs by a metal bracket.Â* The beams in one upstairs
room are similarly fastened to this first large beam, so they are
aligned with all the others.Â* I'm assuming that the paramount (I think
it is called) board, and the vertical bits of wood that hold it in place
(about an inch and a half square section) are not supporting this large
beam; but before I start sawing through it all, I'd like to hear some
opinions :-)

I'd pay a couple of hundred to a structural engineer.


I know this description probably doesn't help at all, but is it ever the
case that a paramount board stud wall can support a beam going across
the top of it?Â* I mean, if it ever got wet, it would be catastrophic :-)
Stuids dont mind wet.

The boarding is at best only there to prevent bowing and 'slender column
failure' (Euler)

--
The lifetime of any political organisation is about three years before
its been subverted by the people it tried to warn you about.

Anon.