k wrote:
Hi I need to cut a 3/4" wide slot 5" long through my piece of wood. The wood I am cutting is 8"x 8"s x 3/4".
I have roughed out a 1/2" slot. When I tried to cut the 3/4" slot it grabbed the wood and chipped off the front edge. I understand grain and why it happened (climb cutting). Does anyone have advice on how to accomplish this task.

You seem more savvy than me. But, FWIW, I would consider
shallower cuts and the use of a fine rasp (near the front edge,
since that is where you had issues).

Bill


The slot is to long for the table saw. I can use a mortise
and tenon machine but was hoping to use the router table with one
pass. I am going to use a 1/4" diameter router bit with light
cuts to finish unless there are any suggestions. Thanks