On Tue, 20 Jan 2004 09:52:59 -0700, "SQLit"
wrote:


"Jim" wrote in message
. com...
Our water softner (Benson Water Conditioner) was installed after being
moved from our old house. The installer put it in and left it
unplugged and in bypass mode until I could get some salt pellets.
Well, I put the pellets in and plugged it in. And at the installers
suggestion, ran it through a regeneration.

After I realized it was still in bypass mode, I moved it to 'service'
mode as it was the only other mode labeled. It seemed to complete the
regeneration process and later I looked inside the tank and there
appeared to be no water inside.

Is that because it was in 'service' mode? Like I said above, there's
only two modes, bypass and service. Is service mode the normal
operating mode or is it between bypass and service which is not
labeled?

Please help.

Jim

You probably forgot to put some water in the tank. Depending on the size is
how much water you need to put in. Then run regen again.

except that the softener should put the water in, if it is in the
service position.