Posted to uk.d-i-y
|
|
BIB tap connectors
"Jim K" wrote in message
o.uk...
"Rod Speed" Wrote in message:
"Jim K" wrote in message
...
"Rod Speed" Wrote in message:
"Jim K" wrote in message
...
"Rod Speed" Wrote in message:
"Jim K" wrote in message
...
"Rod Speed" Wrote in message:
"Jim K" wrote in message
o.uk...
"Rod Speed" Wrote in message:
"Jim K" wrote in message
o.uk...
"Rod Speed" Wrote in message:
"Jim K" wrote in message
o.uk...
Wrote in message:
On 19/07/2018 17:50, wrote:
On 19/07/2018 17:45, Jim K wrote:
Wrote in message:
I've fitted a couple of 3/4" BIB taps but the thread on
the
outlet
seems
to be 7/8" BSP and I can't find an adaptor to a more
sensible
size
such
as 1/2", 3/4" or 1". Any suggestions on where to find an
adapter?
Hosepipe set?
istr just the adaptors eg hozelock on eBay /Amazon.
AFAICS they are only for 1/2", 3/4" and 1"
I forgot to add ... there's an expensive 7/8 adapter for
Hoselock
(Atoni) but I would prefer to adapt to a standard thread.
How do you know you've measured it correctly?
Don't have to measure it correctly, just find it doesn't work
with
1"
or
3/4"
So it must therefore be........?
What is buyable between them, stupid.
You assume it's been measured correctly
Nope, just notice that its bigger than 3/4" and smaller
than 1" and that 7/8" is seen as well, stupid.
The op doesn't say he's actually got any to try though does he
He must have if he has noticed it doesn't fit, ****wit.
No you illiterate retard, he says he's measured it...
He measured it because it didn't fit, ****wit.
Maybe he measured the tap before he went to buy the adaptor
Unlikely. He is much more likely to have tried what
he already had and found it didn't work, ****wit.
reams of your **** any 2 year old could leave for dead flushed where it
belongs
|