On Tue, 19 Jun 2018 09:50:42 +0100, Muddymike wrote:

One of mine did that after being overtightened. I just unscrewed it
fully, clamped the other end in the vice and heaved on the end of the
threaded bit! That was probably 10 years ago and its been fine ever
since. I'm just careful not to overtighten that one.


They don't make G clamps like they used to. BnQ are doing set of 3 I saw
when I happened to visit them a few days ago. They're rather small but
for £3.50 the lot you can't grumble - even if they don't last.



--
This message may be freely reproduced without limit or charge only via
the Usenet protocol. Reproduction in whole or part through other
protocols, whether for profit or not, is conditional upon a charge of
GBP10.00 per reproduction. Publication in this manner via non-Usenet
protocols constitutes acceptance of this condition.