On 16/06/18 18:13, Tim Watts wrote:
On 16/06/18 18:10, Jim K wrote:
Tim Watts Wrote in message:
I have to make up a shelf from planks (800mmx600mm).
My first thought was biscuit jointer, but they're not cheap for
something I will use very sparingly.
I am wondering if a good dowelling jig might be a better investment?
Biscuit bit in a router?
I don't have a router
But as I might be interesting in getting one, I will have a look - ta.
Never heard of those...
Ah - I see...
The only difference I can see is the lateral alighnment (or not). Is
that too important, or does one just make the slot a bit wider than needed?