On Wednesday, June 6, 2018 at 2:41:34 PM UTC-5, wrote:
On Wednesday, June 6, 2018 at 12:50:12 PM UTC-6, Uncle Monster wrote:
A famous man once said,"Experience is a fool's best teacher." Leave the old timer in place and connected then turn it with a screwdriver to switch it to defrost mode. Unless the internal contacts are burned up, it would be much safer to leave the old timer in place. What usually fails is the clock motor so you should be able to turn the shaft at the front where a flat bladed screwdriver can only turn it one way which is usually clockwise. O_o

Uncle Monster, thank you for saying, in so many words, "safety first, for cryin' out loud." I have the timer out and checked for when I have continuity to the compressor and when I have continuity to the heater. It seems reliable enough just turning the dial. I think your plan is going to work.

I repaired a lot of refrigerators when I was able-bodied and working. I did a lot of refrigeration work mostly commercial but I did get quite a few calls to repair consumer refrigerators. Heck, a lot of small restaurants had consumer refrigerators. I've even repaired them for pharmacies. A consumer refrigerator will last for many years if the condenser coils underneath are kept clean. The old fridge with the condenser coil up the back seems to last forever even though you must defrost them manually. Of course, there is always the idiot who pokes a hole in the aluminum evaporator that holds the ice trays with an icepick and all the freon leaks out. The repair cost from a big service company may exceed the cost of a new imported refrigerator. If you have a modern side by side refrigerator that has the condenser underneath with a fan to push air over the coils, you should try to keep the coils clean. You may feel hot air blowing out from under your fridge. You can remove the grill from the bottom and you can buy a special long brush made for cleaning the coils and along with a vacuum cleaner, you can get rid of the accumulated dust and dirt. The professional supply houses sell the brush and Home Depot sells a dryer vent cleaning brush that will work. Like anything, you'll find other uses for it. ^_^

http://www.appliancepartspros.com/pr...ap5631860.html

https://www.homedepot.com/p/Ettore-D...8400/204267902

[8~{} Uncle Fridge Monster