Hi All

So firstly the good news. Keypad has been moved and wired back in without needing to extend the wire.

Now the bad news. The keypad correctly displays the time and the fact that the system is in engineer mode. When I press the buttons on this keypad it beeps as normal but the display doesn't change. When I enter the engineer code to come out of engineering mode on the other keypad, it checks for tampers and then says there are 2 things missing on the circuit
1. keypad 1
2 prox 1

Any ideas? Is there something special about keypads? System is a Honeywell Galaxy 2

This all

Lee