"Roger Mills" wrote in message
...
On 29/03/2018 13:44, Bryan Mitchell wrote:
In view of my historic , and generally lost battles with PTFE tape, I am
now
contemplating the use of LS-X compound with my new radiator valves, and I
would value comment on this please.


What's your problem with PTFE tape? I always use tape intended for gas
connections - it's thicker and stronger than the standard stuff. Also,
when fitting radiator valve tails into new rads, I run a 1/2" BSP tap into
the hole first to make sure there are no rough bits on the thread.
--
Cheers,
Roger
____________
Please reply to Newsgroup. Whilst email address is valid, it is seldom
checked.

Here's an "old and new" idea.....

My dad always used hemp and boss white on screwed joints, so I've modified
this a bit, and on awkward threaded joints (ie outside taps that inevitably
end up 30 degrees from where you wanted them) I use hemp and LSX. Jams
nicely where I want, no leaks (so far), and works well on rad tails too.

I've got enough hemp to last me 40 years at current limited rate of use, but
rather to my surprise found it's still readily available in hanks.

Just a thought.......

Charles F


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus