On Saturday, January 13, 2018 at 4:14:12 PM UTC-6, Sonny wrote:


I'm suspecting your fences are not in line, on the same plane, parallel.... hence the "wobble" in the motion of the run through the cutter, i.e., it's not the movement of your hands or hands' position.

There's a technique for making a curved edge (an arch), using the jointer: Lower the outfeed table, hence, you get an arced/arched edge. This seems to be similar to what you are experiencing, but you are blaming it on your hand-movement positions.

Check that your fences are coplanar.

Sonny