View Single Post
  #8   Report Post  
Posted to rec.woodworking
[email protected] krw@notreal.com is offline
external usenet poster
 
Posts: 2,833
Default which cutoffs for firewood

On Fri, 17 Nov 2017 08:17:27 -0600, Leon lcb11211@swbelldotnet
wrote:

On 11/17/2017 7:14 AM, Iggy wrote:
replying to Electric Comet, Iggy wrote:
All untreated wood cut offs are perfectly fine and don't give off anything
that isn't already in the air for one, but also what they do give off
becomes
harmless within hours or up to a few days (see - "Wood Smoke and Your
Health",
including its right side panels
https://www.epa.gov/burnwise/wood-smoke-and-your-health ).

However, in the case of Painted or Pressure Treated Wood (low-grade wood
for
outdoor use) they should not be burned and only thrown in the trash for the
landfills (yes, your cheap wood or plastic composite deck is very far from
ecological), because they're full of petroleum distillates and pesticides.

All wood releases toxins and for that matter anything burned does too, yes
even your favorite cut of meat with grill marks or toasted bread is a now a
carcinogenic delight. Chimney liners, Stove pipes, Flues, Fireboxes and Ash
bins or pits should be scrubbed clean annually and handled as a Hazardous
Operation with all debris staying off you and going immediately to the
outdoors by a strong fan(s) or into a HEPA filtered vacuum.



Be cautious when burning wood scraps, they burn much more intensely than
typical fire wood.
Scrap woods are much dryer and a little goes a long way as far as heat
out put. I would advise against building a large fire inside of a fire
place with just scrap wood.


Yes, scraps will have more surface area, too. It would make good
kindling, for the same reasons that too much wouldn't be a good thing.
OTOH, scraps should be OK in a wood stove, where the fire can be
throttled back.