Thread
:
Range of ER32 collets?
View Single Post
#
4
Posted to rec.crafts.metalworking
David Billington[_2_]
external usenet poster
Posts: 311
Range of ER32 collets?
On 03/11/17 16:27,
wrote:
On Fri, 3 Nov 2017 08:54:08 -0700 (PDT), Daniel Koller
wrote:
Hi Folks,
If I were to buy one of these sets of Chinese made ER32 collets on e-bay
(
https://www.ebay.com/itm/19pcs-ER32-...100005.m185 1
)
...what is the range of each collet? With increments of 1/16" can I hold any size rod?
If I have 3/16" and 1/4" for example, do I need 7/32"?
I see that the 20 piece set that I linked, has incrememts of 1mm. 1/16" is 1.6mm so it seems to me I would have gaps if I only got 1/16" increments.
Right now I am using a MT3 collet set, but I am finding it pretty limited. It holds nominal stock sizes just fine, but if I take a few mils off to clean up the OD before chucking it, the rod slips.
Thanks for the advice!
Dan
p.s. Intended use is on a 1952 Logan 10" (Wards) lathe. MT3 taper in the head, MT2 in the tailstock.
ER 32 collets were designed to have a range of .032". 1mm is kinda
pushing it.
Eric
Some say otherwise
http://en.wikipedia.org/wiki/Collet#ER_collets
.
Rego-fix are Swiss so I would have expected a 1mm range would make more
sense than 0.032", see
http://ch.rego-fix.com/en/products/system/er
.
Reply With Quote
David Billington[_2_]
View Public Profile
Find all posts by David Billington[_2_]