On 10/12/2017 5:59 PM, -MIKE- wrote:
https://photos.app.goo.gl/DqXrs5DI2roJTli22

I need to replace the white board above this garage door. The 2x12 is
rotted out pretty bad. It will just fall out when poked with a
screwdriver or putty knife, so I'm going to replace with a new, treated
2x12.Â* (Client wants cheapest option.)

What I need help with is figuring out how to transfer that arch to the
new 2x12. This isn't an arch that was drawn with a radius or trammels.
If this was a perfectly cut arch, I could just determine the radius by
bisecting the chords and extending perpendicular lines to find the radius.

If you look closely, you will see that it's not even and the arch
"flattens out" near both ends. So I believe I'm left with trying to
transfer the exact line of the bottom of the soldier course of bricks to
the new 2x12.

Remember, the existing 2x12 will not come out in one piece or even
several pieces which could be reassembled to use to trace the "arch"
onto the new board. It's pretty much, mulch, held together with paint.

Any ideas?


Scribing a 2x12 to match is the easy part. Cut it with a couple degrees
of back bevel so it slides in easier, and any high spots can be easily
planed off.

Sealing it so it does not rot again will be the real problem.