"Ned Simmons" wrote in message
...
On Sat, 30 Sep 2017 07:27:21 -0400, "Jim Wilkins"
wrote:

"Ned Simmons" wrote in message
. ..
On Sat, 30 Sep 2017 03:29:34 -0000 (UTC), bob prohaska
wrote:

Ned Simmons wrote:

Try "face spanner."

The photos all seem to come up with round pins; did I miss
something?

The gland nuts I'm dealing with have rectangular notches. Pins
might
work, but they seem precarious.

A couple with square or rectangular pins:
https://www.amazon.com/Stanley-Proto.../dp/B001VXTV82
http://tinyurl.com/yd92oru6

I've made tools similar to the second example to reach bearing
locknuts in a recess where a hook spanner won't work.

Face spanners of a different sort:
http://l7.alamy.com/zooms/4baf2b5d64...ner-aktmyy.jpg
https://cdn4.i-scmp.com/sites/defaul...?itok=tu144kGF


The snap rings you pictured are often called Eaton rings, though
most
I've encountered are hard.

Thanks, that's a term I've not encountered before.

bob prohaska

--
Ned Simmons

Do you know the name for the 'w' shaped soft iron (?) flat rings? I
found round wire ones by searching for hog rings.
-jsw


Like this?
http://sg.misumi-ec.com/vona2/detail/221000104156/

Turn them 90 degrees and they're E-rings.


--
Ned Simmons

Like this but flat stock, with semicircular instead of squared ends:
http://www.loadrite.com/wp-content/u...11/p-17760.jpg

I thought they might be punched mild steel retaining clips that crimp
into the shaft groove, as on the OP's jack wheels. The ones I saw were
much thicker than hardened C or E spring clips.

-jsw