On 24/07/2017 17:05, wrote:
On Monday, 24 July 2017 16:26:50 UTC+1, John Rumm wrote:
On 24/07/2017 13:37, tabbypurr wrote:
On Monday, 24 July 2017 11:34:54 UTC+1, John Rumm wrote:
On 24/07/2017 09:59, tabbypurr wrote:
On Monday, 24 July 2017 02:03:48 UTC+1, John Rumm wrote:
On 23/07/2017 20:53, jkn wrote:

Hello all This is an enquiry about how to use a router to cut
a slot in the end of a sheet of wood.

Below is an ASCII-art side view of the sheet. The wood is
around 18mm thick.

The slot needs to be say 3mm across, and perhaps 15mm deep.


| | slot approx 3mm from edge

| | 3mm slot, 15mm or so deep

/ / / / / / / / / / / / / / / / |-|
|------| | | | | | | | | | |_| | | |
| | |SIDE VIEW |

| ~18mm | thickness of wood

I have a Router (1/2" chuck) available to me. I originally
presumed that the approach would be to get a suitable 'deep
pocket' router bit and cut the slot in several passes.
However I cannot find such a router bit and am wondering if
there are any other options.

You will have difficulty finding a 3mm straight fluted bit -
and if you do, it will be very weak so you would need many
light passes to get to depth.

A 3mm diameter cutter can not do that, no matter how many
shallow passes you make. I know because I have one.

What you know is that your 3mm cutter can't do it...

The limitation with any straight cutter with flutes narrower than
the shank is that they will only have a limited depth of cut before
you hit the tapered section. On many cutters of that type, the max
depth is usually no more that 1/2", which given the OP suggested
"15mm or so" may or may not be adequate.

You can get 1/8" shank router cutters, which for 3mm fluted cutters
will not have the same limitation on depth of cut. You would need
either an adaptor collet for a larger machine, or a small detail
router like the Dremel style add on:

https://www.amazon.co.uk/Hakkin-Tita.../dp/B0187AYWE4




(However as I highlighted previously, there are other and better options
in this particular case).

Whoosh. The limitation with 1/8" sideways cutting bits is the lack of
lateral strength. Try to cut the op's slot and they will just break.

Are you just arguing for the sake of it again?

No they won't break with a lateral pass - its a router cutter not a
drill bit. Yes you will need to take light shallow passes - as I already
said above. With each pass the load on the cutter is at the tip where
its doing the cutting. If it survived the first pass, the following ones
should be no harder.

Having used such a thing I know what you discuss there is optimistic.

I have never broken a 1/8" router cutter (or any other for that matter)...

(chipped a few though)


--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/