Steven Bliss wrote:

I've done enough home repair & woodworking in my house to be pretty
comfortable with most anything "intermediate". I need to replace my front
door. I've bought an exterior door, framing is exact same size as the old
door (yes, I also measured the rough opening as well...the sticker on the
door frame said what I needed, and I'm where I should be). New & old are
steel, no side lights. It seems like everything is straight forward. I'm
intending to leave the door attached to keep the frame from racking while
installing. Seems like the easy way to do it for me. The door was shipped
with two small nails going from the outside (rough opening side) into the
door & left backed out about 1/4" . I'm thinking that I can install, then
cut the nails with a hack saw & setting them in the rest of the way. Putty
& then I'm done. The shims, finishing, Level & plumb, etc, I'm pretty
comfortable with. What's the word out there, door attached or unattached
when installing?

--
i bet it is easy to set the door with the frame on and all, but how you
gonna drive nails or screws into the frame from the door opening when
the door is in the way.. i got to buy a door for the side of my house..
a utility door.. third wooden outside door there.. weather got to the
outside skin... i saw some at home depot for about $95.00 in the frame,
but when looking at it i discovered that it was very thin sheetmetal and
the top and bottom of the door was open and not covered in metal...
under the metal is particle board... granted there is no trim on these
door yet, but it seems that the rain is gonna get into the 1/4 inch
opening on the top of the door and then swell up the partile board
inside the metal door and cause troubles....
can you recommend a place and price for your new metal door and does it
have metal on the top and bottom of the door?????
thanks...