nad AV-716
Steeve,
I've got a service note that I wrote down about a common failure in the
AV-716. R921/922/923 (all 0.47 ohm) and R924 (33 ohm) have a tendency
to open. I always replace all four resistors, and I increase them to
half watt flame proof resistors instead of the 1/4 watt ones the factory
used. All of these are on the main PCB near the area of JL701A, the
flexfoil cable connects. Of course, there are other reasons that your
amp could have failed, but this is easy to check.
Regards,
Tim Schwartz
Bristol Electronics
rouleau wrote:
Hello i have a nad AV-716 wont power up the first power supply click but
nothing happen look like the uprocessor not working voltage on regulators
look ok
i have no schematic
thank's
Steeve
|