uPVC French Doors - stripped screw holes
On Wed, 24 Aug 2016 14:32:37 GMT, DerbyBorn wrote:
Doing a routine clean and lube on my french doors and found the bottom
locking mechanism strip a little loose. Tried to tighten the screws and a
couple turned without gripping.
Any ideas on how to close up the hole to give the screws another chance or
am I looking and drilling some fresh holes in the locking bar?
Had this on some windows, so used some stainless steel self-tappers from TS.
They were a bit bigger and 'bit' well in the same holes.
IIRC, oversize screws with the 'correct' thread are availabble.
--
Peter.
The gods will stay away
whilst religions hold sway
|