Did you mark all the plugs going to the convergence panel? It looks like you
may have gotten the yoke connectors swapped around. Make sure rhe yokes are
connected according to CRT, Red on the red crt, etc.
--
Jammy Harbin
J & J Electronics, Inc.
227 S. 4th St.
Selmer, TN 38375
731-645-3311
"Jens Ratsey-Woodroffe" wrote in message
et...
I posted a while back about repairing a Pioneer rear projection TV that
had
a convergence problem. I've replaced the IC that was recommended to me.
The good news is the TV still works (remember I'm no TV repair guy); the
bad
news is the convergence is now way off - far worse than before. This is
now
what it looks like:
http://www.ratsey.com/ti2/pioneer.jpg
Am I going to have to resort to professional repair for $$$? Remember
this
is an 8 year old TV that's already been replaced by a plasma and has been
retired to the basement where I was hoping for a few more years before
getting an overhead projector.
Any advice?
J.