I have gerberit which I installed, There is one screw at front holding on surround and skirt sort of fits in slots and floats resting on floor, it is supplied with 3 skirt sizes depending on height above floor but is usually fitted with the smallest skirt which is abot 50mm high,so you should be able to push skirt up by hand in its slots with out moving surround to make sure you have clearance for floor covering. If you have enough clearance then remove front screw and pull surround forward and fit covering. Toilet sits on a rectangular metal frame with 4 feet.

steve
On Sunday, July 10, 2016 at 9:28:47 AM UTC+1, Mick IOW wrote:
On Sun, 10 Jul 2016 06:50:55 +0100, Andy Burns
wrote:

Mick IOW wrote:

I have just had an Geberit AquaClean 8000plus Care installed in my
flat. Can I remove the bottom skirt of the Geberit AquaClean to
enable the floor covering installer to fit the new floor covering
well within the skirt, and if necessary trim the bottom skirt to re
fit it.

Sections 25-28 of the installation manual

http://www.geberit-aquaclean.co.uk/media/local/gac_8000plus_care/GAC_8000plus_care_installation_Manual.pdf

show that it comes with three different skirts, and the one that is
fitted depends on the seat height you have it installed for, but that
there is some up/down adjustment of the skirt.

Thanks for that, I wonder why the installer did not leave the unused
ones, could have been helpful if I mess up trying to trim the one on
there, I expect they have been dumped but I will contact them.
Mick.