I ALWAYS said they did - from Zero to about .1" is the spec.
Martin

On 6/16/2016 2:22 AM, steve robinson wrote:
On Wed, 15 Jun 2016 21:39:27 -0500, Martin Eastburn
wrote:

Read. It says set your set by hand. If you need 2" wavy for your
needs then do it. The taper is in the upper part as that is where
the drag/tug occurs. Close to the teeth there is more power in the
saw than drag. If you need more add more. If you are cutting a $50
board, then use what you want to do.

Martin

On 6/15/2016 10:07 AM, steve robinson wrote:
On Tue, 14 Jun 2016 22:32:01 -0500, Martin Eastburn
wrote:

snip

You do realize a taper ground saw isn't ground uniformly along its
length plus they are not ground to the teeth



So you now finally agree ripsaws have set