Thread
:
Home Phone Wiring Repair
View Single Post
#
21
Posted to alt.home.repair
Colonel Edmund J. Burke[_16_]
external usenet poster
Posts: 1,494
Home Phone Wiring Repair
On 4/28/2016 5:47 AM,
wrote:
My phones have no dial tone. My DSL internet works fine. When I call my home number from my cell I hear ringing, but the phones in the house don't ring.
I disconnected all phones and tested one by one. All dead. Still have to replace all the DSL filters one by one. But could they all 5 go dead at once? Could a surge go through the lightning arrestors, knock out 3 phones, leave the DSL router and answering machine untouched? I don't think so.
I don't have an NID. It's 1970s wiring, Bell System. The incoming phone line is in the basement and terminates on a lighting block arrestor. Two maroon solenoids on the sides with incoming wire connected above, and phone lines below.
I hooked up a two wire, red and green jack with RJ11 connector to the incoming wire posts and connected a phone. No dial tone.
So I'm thinking this is not a problem in the wiring or equipment in my home.
I'm asking if anyone sees flaws in my analysis.
Will Verizon install an NID in or outside at no charge?
Will I get marginally faster internet if I have RJ45 cable wired from the incoming directly to my router? It's not a long run maybe 6 feet.
Thanks for any expertise you can offer.
The problem is with yer ringer.
Reply With Quote
Colonel Edmund J. Burke[_16_]
View Public Profile
Find all posts by Colonel Edmund J. Burke[_16_]