On Friday, March 4, 2016 at 1:50:28 PM UTC-5, Greg Guarino wrote:
On 3/4/2016 11:21 AM, Electric Comet wrote:
never tried these but like the idea but a little but pricey

http://www.acehardware.com/product/i...uctId=24751286

would come in handy from time to time for a big project that needs
clamping then when you are done you can use the 2 bys for something
else

That picture looks like it was set up by the art department. I would
have to assume that any woodworker would position the movable jaw such
that the crank handle was past the end of the 2x4. What a pain it would
be to tighten it where it is now.

Slide, turn, slide, turn, slide, turn. I've often had to position C-clamps such that I
couldn't make full turns with the handle.


I'm pretty sure you could get 3/4" pipe clamp hardware + a pretty long
pipe for about the same amount.