On Mon, 28 Dec 2015 00:30:14 -0800, Gunner Asch
wrote:

On Mon, 28 Dec 2015 01:38:13 -0500, Tom Gardner
wrote:

On 12/27/2015 7:00 AM, Steve W. wrote:

Actually there is a market for the shafting but probably not a ton of
money. There are quite a few folks out there setting up line shaft
driven shops and museums. The problem is getting the info out.

What is the Bridgeport? 3phase? Tooling?


The BP is my pride and Joy! 3-ph, 2hp. variable speed. Pretty complete
R-8 tooling, XY DRO, power x. One shot oiler. Like new, not a scratch
(almost)

So take it home and use it in your home shop. Put in your will Roger
gets it when you "loose interest"

Most they are worth is about $5-7k in good condition..at best. And at
an auction..probably about half that..at most.

Most..most auctions are held for dealers..who pay much less than full
market value so they can sell at market value +/- and make a living.
Id never pay full boat for a piece of machinery. Ever.

Gunner
But if a hobyist (or 2) was at the same auction you wouldn't get it
either. I've seen "home shop compatible" equipment bir up to almost
new list at auctions in my area. There is a local auction place that
sells fleet vehicles, banctrupt business eqipment and stock, recovered
goods from the PD, equipment from local school boards etc - and very
little machine tool equipment goes cheap.