View Single Post
  #6   Report Post  
Posted to uk.d-i-y
rick rick is offline
external usenet poster
 
Posts: 937
Default Another Q on screw fixing external wood cappings

On 06/12/2015 09:19, stuart noble wrote:
On 05/12/2015 16:16, Phil L wrote:
rick wrote:
On 05/12/2015 15:33, Phil L wrote:


Yes, use concrete cappings, timber won't last 18 months



That is not much use .... I couldn't use concrete cappings easily as
overhang would be too great ... in any event I have bought the wood.

What width is the wall?

Don't know why you think it will only last 18 months.
Fully pressure treated Tanalized timber plus finish coating on top
will last a lot longer than that ..........


How many walls have you seen with a timber capping all along it's length?
FWIW, the sun does more damage to timber than anything else - in the
extreme
heat of summer it tends to twist and split, this allows insect, fungal
and
mould attacks. 18 months may be a bit low, but it will rot



Unnecessarily pessimistic. The *upper* part of fences last for decades!
If the OP can engineer a small gap between masonry and wood, that would
help. Also, it's mainly water going into the end grain that causes rot.
Sealing the ends of the capping with candle wax might also help.
FWIW & IME I have both tanalised and untreated wood (above ground level)
in my garden, and they have lasted equally well. I certainly wouldn't
use a "coating", which invariably becomes a maintenance nightmare.




Wall is 110mm (single brick course)

I intend fitting full wall width 5mm thick plastic spacers between wood
and wall ...
Thought of using one of these at each screw fixing:
http://tinyurl.com/jtbvz8h

The wood is fully pressure treated, plus I will apply 2 coats of Sadolin
Classic Natural finish.
The reason for coating is that it will then match the cladding ... which
does need coating.

None of this is in contact with the ground.