On Saturday, September 5, 2015 at 4:29:53 PM UTC-5, Stormin Mormon wrote:
On 9/5/2015 4:02 PM, wrote:
On Sat, 5 Sep 2015 10:25:02 -0500, philo wrote:
The new "back feed" devices are pretty good. They don't use a
springtab - they use a screw but do not require bending the wire to
fit around the screw, and the co-alr devices have a set pressure due
to usre of a bellview type spring washer.
Some I've seen, I call em back clamp. Which
is fine with me.
-
.
Are you referring to the type where you must tighten the screw after sticking the stripped end of the wire through the hole in the back of the wiring device?
If it's what I'm thinking, it's a commercial grade device that I've used with stranded wire. You can also side wire them. ^_^
[8~{} Uncle Wire Monster