View Single Post
  #11   Report Post  
IMM
 
Posts: n/a
Default Keston Questions (noise and flue options)


"fred" wrote in message ...
In article , IMM abuse-
writes

"fred" wrote in message ...
In article , Andrew andrew@
sPydata.uklinux.net writes
Paid a visit to the homebuilding and renovating show at Bath and West
show ground yesterday (sat - also on today 30/11/03).

Bloke on the Eco-hometec stand said if you can't afford one of ours

then
given choice of Valliant thermocompact or Keston Celsius get the

Keston.
They seem like be a nice bunch, I spoke to them a bit before deciding

that
I couldn't justify the extra cost of their (excellent) boiler. I chose

the
Keston.

In the Keston documentation there is a sentence (underlined) that says
consider the possibility of the noise if installing near to a living
area. Can anyone with a Keston comment on this ?.
I have it in the corner of my kitchen and do not consider it to be
excessively noisy, but this is a long way away from the main kitchen
action. It does have a powerful flue fan which is noticeable and could

be
obtrusive in a quieter area. I will be boxing mine in the long term.

Flue options - the best place (for boiler) is under the stairs (only 6
feet from the 3/4 inch iron gas pipe supplying the kitchen) and the

flue
can follow the underside of the stairs then go horizontally towards

rear
of kitchen and follow the 110 waste water stack up the loft, then

either
up to the ridge or out and down through the soffits.

Why can't I connect it to the waste stack ?. - i.e. well above the

'high
tide mark' ?
They want the intake and exhaust flues to be balanced, that means
running two 50mm uPVC pipes to your chosen exit point.


Are you sure? The advantage of twin flues is that the exhaust and air

feed
can be in very different locations. The two pipes don't have to be near
each other or the sae length. For e.g, the exhaust run up to a ridge

tile
and the air intake under the floor and penetrating the walls at low

level.

If the air intake is taken to an external wall and the exhaust to the roof
ridge then there is a danger of wind pressure imbalancing the flue.


So little it is not worth considering. "most" twin pipes systems can have
exhaust and air intake in different locations, that one of the clear
advantages of twin pipes.

I agree
that if the intake air was taken from a wind neutral space, say

underfloor,
then that argument would be voided, but Keston specifically state that
taking air from underfloor (or not from outside) will void the warranty. I
assume that they are concerned about intake of dust etc into the
combustion space and resulting damage.


I didn't say take the air from the airspace under the floor. This would
drag very cold air under the floor cooling the house, the same with taking
it from a vented loft space too (this is silly as insulation dust could be
dragged in.



---
--

Checked by AVG anti-virus system (
http://www.grisoft.com).
Version: 6.0.542 / Virus Database: 336 - Release Date: 18/11/2003