ok, here is what you want to do.

Pin1 is your VCC, and you need to put your DMM on DC.

you like you said, probably at 0volts. well, trace that foil line, and you
will run into a diode, one side of the diode is DC, and if you see 0volts
then go to the other side and put your DMM on AC, and see if its a 0volts,
if so, then keep going, then you will see a part that starts with an R, then
one side will be 0v, and the other will be 12 or higher volts. the other
side should run to the flyback winding.






"Daniel M" wrote in message
ink.net...
Ok, so do you know the designator or location of the resistor so i can
check. In just probing around they all looked good but i could have missed
the right one. Also i have already replaced the IC.

daniel.

"Mike" wrote in message
...
can be, but not always necisarrily the case. my magnovox IC died, and i
replaced it, the fuse, and teh DC diode rectifier, and all was well.





"kc8adu" wrote in message
...
and the lytics around the ic went high esr and killed it.

"Mike" wrote in message
...
the fusible resistor providing the B+ has opened, because that IC
has
failed.




"Daniel M" wrote in message
arthlink.net...
I need help with a SJ2065S5 Zenith TV. All i have is a horizantal
line
across the screen. I have looked at the LA7837 and i apparently am
not
getting VCC to the chip. 0vdc.

Can anyone give me a location to try next? I have not been able to
find
R3242 on this board. This is the 20" not the 27".

Thanks.

daniel.