Paul,

Hmm..."whited out"... this is the part that gets me. A whited out area would
mean that the LCD crystals in that area are being turned *on*, usually LCD
faults
work the opposite way (blacked out.) Without seeing it for myself, I would
gather
that there is some kind of problem in the video adapter. That's worse cast
scenario.

Everything else also sounds a lot like the problem I had with my IBM
Thinkpad. It was the backlight that needed replaced. Do you have a key on
you keyboard to switch between the LCD and an external monitor? Try
switching it when trouble strikes. This turns off the backlight and then
triggers it again when you switch it back. If it helps (even just for a few
seconds) it may be the lamp.

Also, like Dave mentioned, if you are not squimish about opening the laptop,
do as he suggested. Usually, you can get to the LCD cable by gently prying
up the panel above the keyboard. There may be a screw or two on the back at
the hinges. Lay the LCD as flat as possible before pulling up the plastic
panel.

If none of these things work for you, then you may need to check ebay for a
replacement LCD or start shopping for a new laptop. If it isn't the LCD,
cabling, or backlight then the necessary repair would likely be very
expensive (not that replacement LCDs are cheap!)

Scott
"Paul Burridge" wrote in message
news

Hi all,

I have a Compaq Armada 1750 laptop and the display's developed an
intermittent fault which at times is bad enough to make the screen
totally unreadable. It doesn't seem to be temperature related and can
happen at any time. The most noticeable problem is kind of like
slender, white, verticle streaks going down the screen which flicker
and vary in intensity. At worst, the whole screen apart from the top
quarter inch along the top becomes whited out. Anyone have any idea
what might be the cause of this problem or how to fix it?

Thanks,

p.
--

"I believe history will be kind to me, since I intend
to write it." - Winston Churchill