On Tue, 07 Apr 2015 17:21:14 GMT
(Scott Lurndal) wrote:

complain, complain, complain.

no
confirmed observations
you can check your self


That said, for amateur dovetails, get a stanley dovetail saw
from home depot or lowes for a few bucks; take a ball-peen
hammer and an anvil (or the anvil on a bench vise) and carefully
reduce the set, evenly on both sides. Don't remove the set
entirely, but minimize it. Then test the saw in some end-grain;
if it doesn't follow your line, the set is probably asymmetric and
you'll need to adjust as necessary.

have watched some videos on setting the saw
it gets hard to do with higher number of points per inch
need to break out the magnifier