On 2/7/15 11:24 AM, wrote:
On Sat, 07 Feb 2015 07:55:27 -0700, Brewster wrote:

On 2/2/15, 2:09 PM, dpb wrote:
On 02/02/2015 2:38 PM, DerbyDad03 wrote:
...

I vote against Al because it tends to gall/stick worse than steel.

Other than that I have no real strong opinion although I am partial hard
maple as the material of choice simply 'cuz it's easiest to sneak up on
the prefect fit...even the purchased steel runners are typically a
little sloppy...

--


'sneak up' is the key here.

I've read (and it's true for my tablesaw) that Delta slots are a tad
over 3/4". This makes using a piece of 3/4" Aluminum bar not so good
unless I use both miter slots and shift the bars together (or apart) to
rub on a single edge. Every aftermarket miter slot dodad I have gives me
grief. The bulldog featherboard works great, but I have to tighten the
snot out of it to get the expanding wedge to grip the miter slot tightly.

Using wood lets you get a perfect fit.

Incra (and others) make adjustable miter bars to solve this problem.
http://www.rockler.com/incrareg-miter-slider-bars


Those work very well for most applications.
But damn if they don't scratch the hell out of everything! :-p

Haha! Seriously though, that's a great product.


--

-MIKE-

"Playing is not something I do at night, it's my function in life"
--Elvin Jones (1927-2004)
--
http://mikedrums.com

---remove "DOT" ^^^^ to reply