On 1/27/2015 9:04 PM, DerbyDad03 wrote:
I tried my hand at stub tenon joints tonight and ran into an issue. I think may need to buy a stacked dado set.

I have an Excalibur twin blade dado set:

Too bad. Tkat's much more cove than you would normally get with a well
made, properly set up and mounted, two bladed wobble dado in good shape.

If you took the time to set it up properly and it makes that much cove
in 1/2", it is indeed a POS, so toss it.

Sorry it didn't work out for you, but I got the impression, since you
had a new router table, that you didn't want to spring for a stacked
dado set, so it was worth a try, eh?

Lots of ways to clean that up, low angle block plane, pattern makers
rasp, router table/straight bit, table saw with regular kerf blade, for
starters.

The only question is/was - do you want to take the time to clean them
up, or spend the money on a quality tool?

--
eWoodShop: www.eWoodShop.com
Wood Shop: www.e-WoodShop.net
https://www.google.com/+eWoodShop
https://plus.google.com/+KarlCaillouet/posts
http://www.custommade.com/by/ewoodshop/
KarlCaillouet@ (the obvious)