"Leon" wrote in message
...

http://ezine.woodworking.com/JigBase...Jig/index.html

Notice on the video how long it takes to drill the holes when drilling at
this angle and also notice how the pieces don't stay aligned. There was an
obvious twist on the corner joint.

There were a number of problems... the warped center stile for one. Also it
appears that either one or both of the rails on the top and bottom appeared
to be warped too. I'll give Ernie the benefit of the doubt on the length of
the outside stiles... his process may include flushing the ends and squaring
the door after it's assembled.

I suspect the warped parts contributed to the alignment problem...

That said, the lack of panels suggests this was strictly a demo for pocket
screws!

John