On 2014-05-31 03:30:47 +0000, said:

On Monday, January 21, 2008 10:08:37 AM UTC-8, TomNie wrote:
Robo
You answered the Oland Tool post with a shear cut remark.

I'm anal about a smooth, flowing finish but a find the scraper is not that
easy to just slide through a continuous cut. This could be my inexperience
trying to use that way. Further, since it's flat, I find it awkward to bring
up enough for a shear cut.

So, I'm thinking of a way too expensive tool at Klingspor's that has a
removable curving plus flat cutter attached to a stout round bar that has
some 1/4" flat on it. Seems this could be maneuvered a lot easier.

Your thoughts? Or anybody else's?

TomNie

I'm trying to get in contact with Reed Gray regarding purchasing one of
his robo rests. Where can I find him?

Robo doesn't hang around here any more, but it's really not tough
http://www.robohippy.net/

I really like my 1st Gen RoboRest, he has done a couple improvments since

Ralph