DIYbanter - View Single Post

Bill[_47_]

Bill wrote:
wrote:
On Mon, 15 Dec 2014 03:11:47 -0500, Bill
wrote:

wrote:
On Sat, 13 Dec 2014 22:00:20 +0000 (UTC), John McCoy
wrote:

woodchucker wrote in
news:6oGdnbZAT_hpDRHJnZ2dnUU7-
:

The rigid is not a cheap tool. It's got an induction motor not
universal
and is surprisingly well made.
Ridgid (two "d"s *) power tools are a bit unpredictable. Most of
them are made by Ryobi, I beleive, with corresponding quality.
Not really (made by Ryobi). Both are made by the parent company, TTI,
(the other name in the TTI group is "Milwaukee"). Ryobi is meant for
the low-end consumer market, while Ridgid is intended for the higher
end consumer and low end contractor. Milwaukee, of course, is
intended for the pro-sumer or industrial markets.

A few of them are made by other vendors (some might even be
made by Emerson Electric, who actually own the Ridgid name and
make the Ridgid plumbers tools), which sometimes means a higher
spec tool.
AIUI, Ridge (Emerson) owns the (Ridge and Ridgid) trademarks but
they're licensed to TTI, who actually manufactures most of the tools.

The tool biz is really convoluted.

Just adding to what you wrote:

In 2014, Tenex Capital Management New York City, NY acquired the JET,
POWERMATIC AND WILTON brands from Walter Meier and changed the company
name to JPW Industries where they continue to grow and outperform their
competition with innovative, quality products and services.

As if you didn't know, all of this consolidation is no good for us!
I'm not convinced. It's better that there is a consolidation than all
of these companies disappearing. The market isn't huge.

Several of Delta's products seems to have virtually (and absolutely)
disappeared since they got consolidated.
I've noticed the absence of their 8" jointer and a couple of their
sanders, and there is most-likely more.

I have Not observed the presence of a Festool OSS! : )
(especially one that wasn't plastic!)

Carvers, if you used an OSS to "cut close" would you expect the sand
paper to leave grit in the wood and dull your carving tools (just
curious)?

Bill

From a brief search, the answer to that last question seems to be Yes.
Though several use a toothbrush and air compressor or shopvac to remove
the embedded abrasives.