Thanks Bill,
I must have been too anxious and miss your article.
I'll go back and read it.

Denis

"william_b_noble" wrote in message
s.com...
well, read my article.

countersink about half of bearing width, use screws, or glue, or press fit
pobably the easist route is to put the bearings into a bored hole, put the
sanding disk shaft through the bearings, and then epoxy the bearings in
place.
"Denis Marier" wrote in message
...
How do we press fit the ball bearings into the wood.
At first, I tough about c'boring on both side of the piece of wood to
press
fit the bearings.
Then inserting the 1/4" shaft and securing it with nuts and washers on
both
sides. The tough crossed my mind that if I place too much pressure on
the
nuts it may prevent the inner ring of the bearings from rolling freely.
Maybe someone can throw some light on the proper way to mount the ball
or
oilite bearings.

"william_b_noble" wrote in message
s.com...
the sleeve will work well - just grease it if it starts to scream.
Bearings
are free, you take them off roller skates, roller blades, or razor
scooters
that have been abandoned, outgrown, or you get them in a thrift shop
for
$3.
Even small towns have childeren that outgrow toys. But there is
nothing
wrong with a brass sleeve - in fact, you can just bore a hole in the
wood
and dip in oil (or wax) and the wood makes a fine bearing - the
pressures
are not that high. I used ballbearings because they were handy - I
have
a
box full of them
"Earl" wrote in message
om...
In my very small town I could find no bearings to make a self
powered
sander...new or used. None! Our local small downtown hardware store
suggested a brass sleeve for $1.26. He knew nothing about
woodturning
but after explaining what I had in mind he came up with the idea. I
bought a 2" sanding wheel for 2.50, bummed some velcro from my wife
and for $3.76 had a sander. It works great. I know the sleeve won't
last like bearings so if I use it alot I will still be buying
bearings, but for less than a couple cups of espresso who can
complain. And as the guy at the hardware store pointed out, alot of
cheap power tools use sleeves instead of bearings and they last a
reasonable amount of time, so who knows how long it will last...

Earl